GoPro Panoramic Mount

GoPro Panoramic TimerA recent project of mine was to use a simple kitchen timer to build a GoPro Camera panoramic time-lapse mount.  This basically lets the camera spin 360 degrees to evenly film the surrounding area.  Either periodic stills can be taken or video can be recorded that can later be sped up into a time lapse.

I started with a basic kitchen timer.  It’s best to find one that doesn’t have a dial on it.  There are numerous egg-shaped timers that seem to work best for it.  Stores like Bed Bath & Beyond or Walmart should have them.  The first one I found happened to be shaped as a lady bug and cost something like $3.99.  The GoPro tripod mount is $8 so with the nut and washers the total was less than $13 to make.

Parts Needed:

  • Kitchen Timer
  • GoPro Tripod Mount
  • 1/4-20 half inch bolt
  • washer [optional]
  • finishing washer [optional]
Tools Needed:

  • drill with 1/4 drill bit
  • needle nose pliers
  • screw driver required
    to take apart (mine didn’t)

GoPro Timer Parts and Tools

I took the red top off the timer by simple pulling it apart with my hands.

GoPro Timer pulled apart

Next I drilled a hole slightly off-center.

GoPro Timer hole drilled

Followed by threading the bolt with the washer on it up from the inside.

GoPro timer bolt threaded through hole

On the outside I put an upside down finishing washer.  This isn’t a must do, but I think it made a better fit for the tripod mount.

GoPro timer added finishing washer

Finally the tripod mount was added.  The needle-nose pliers were used to turn the bolt from the inside while holding the tripod mount straight by hand.

GoPro timer with tripod mount

Complete assembly from the front and side:

GoPro Panoramic TimerGoPro timer complete from side

Gallery of images:

No ladybugs were harmed in the making of this mount.

3 Comments on “GoPro Panoramic Mount

Leave a Reply to jon Cancel reply

Your email address will not be published. Required fields are marked *

*